Technical Information Site of Power Supply Design

Design Support Tools   - 繁體中文   - 简体中文   - Japanese

2019.10.23 DC/DC

Supplement-Protective Function: Output Pre-bias Protection

Switching Regulator Basics

This article is a supplement to " Protective and Sequencing Functions" in " Switching Regulator Basics". In recent years, an increasing number of DC/DC converters have been provided with this protection function.

Output Pre-bias Protection

The voltage Vout when a DC/DC is started is assumed to be essentially 0 volts. However, due to the circuit configuration, restarting after a short time interval, and other factors, a voltage Vout may exist prior to startup, that is, the voltage may not be zero. In many cases, charge remains on the Cout connected to Vout, or on a Cin of the load (the IC being fed) or the like; or, it may be due to a leakage current via another route, or to a bias from a pull-up resistor or the like.

In a state with this pre-bias, when the low-side switch (MOSFET) of a synchronous rectifying step-down converter is turned on, an excessive current is drawn, and breakdown of the MOSFET is possible. In order to prevent such an occurrence, the pre-bias production function executes control so as not to turn on the low-side switch until the output voltage exceeds the pre-bias voltage.

Key Points:

・Protection is provided for a pre-bias state in which a voltage already appears at the output upon startup of a synchronous rectifying step-down switching regulator.

・A function is provided to prevent the possibility of breakdown of the low-side switch due to drawing of an excessive current when the switch is turned on while in a pre-bias state.

Basic of Linear Regulators and Switching Regulators

This website uses cookies.


By continuing to browse this website without changing your web-browser cookie settings, you are agreeing to our use of cookies.